![]() If your audio hardware doesn’t support either mode, you should cut extremely long regions into shorter sections.Ĭheck all frame rate settings. ![]() Open the File > Project Settings > Synchronization > Audio pane and choose MTC Continuous or MTC Trigger + Auto Speed Detection mode in the Core Audio pop-up menu. ![]() When trying to synchronize to tape, there is one key rule: the playback situation must be identical to the recording situation. If an old recording on tape was not properly synchronized to timecode, you won’t be able to use it. Poor or no synchronization to an external tape machineĬreate a new project, then make a new recording in Logic Pro X of the audio on tape. If you see a “Sample Rate xxx kHz recognized” error message, the clock source device (DAT machine, for example) connected to your audio hardware’s digital input may not transmit Word Clock in stop or pause mode (or has switched itself off). If Logic Pro X is synchronized to external word clock (Audio Sync Mode: External or Free), make sure that a valid digital signal is always available. ![]() This table describes common synchronization problems and solutions. Due to the number of synchronization types available, and different implementations by various manufacturers, you may experience timing issues when using Logic Pro X synchronously with other devices or applications. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |